Ethernet cables have that little rubber dome, boot-like thing protecting a plastic release clip and others don’t?

Look no further! At Dove Computers, we stock a wide range of accessories including Ethernet Cable Boots at a pocket-friendly price.

The purpose of the Ethernet Cable Boots

It turns out that removing the boot does not have a deleterious effect on the cable but it is there for three reasons:

1. Ethernet Cable Boots keep you connected

The chief purpose of the boot is to protect the plastic clip from flipping up and eventually breaking off the cable.  The plastic clip, also called a retention clip, makes that familiar “click” noise as you plug in the cable; it snaps the plug into place and secures it there.

Without the clip, would probably randomly get disconnected from your network as the plug would simply slide out with the slightest tug.

2. Ethernet Cable Boots protect the clip

Network engineers often have to pull Cat5 (tech jargon for Ethernet cables) through very tight areas often crowded with dozens of other cables.  The boot protects the clip

• As it makes its odyssey,
• Through the labyrinth of wire spaghetti,
• Around corners
• Through a narrow conduit.

For this reason, Ethernet cables with these little rubber boots are often referred to as ant00i-snag cables because it keeps the clip from catching and halting the cable pull.

3. To protect your nails

It’s easy to get jam the clip under a nail as you try to release or plug-in the Ethernet cable so the boot serves as a barrier to block your trusty thumbs from sliding into it.
If you hate the boot but are afraid to put the cutters to your cable then see if you can gently slide the cable boot down the length of the cable.  Some cable boots are just a rubber hood that is loosely connected to the cable sheath.  If that’s the case it’s easy to slide it out of the way.